Saving Old Seagulls

Hi everyone, does anyone have a contact for a supplier for the brass fuel pipe ends and nuts for the rigid early Marston/SD/early Seagull fuel pipes as they are quite a faf to make and have now run out

Thank you all

Rene

These guys sell the bits:

https://www.holden.co.uk/p/solder_nippl ... opper_pipe

https://www.holden.co.uk/p/1_4_in_bsp_n ... opper_pipe

Or these, a bit cheaper:
https://www.vintagecarparts.co.uk/produ ... ipe-nipple
https://www.vintagecarparts.co.uk/produ ... itting-nut

My home made SD fuel tube turned out fairly well.

Brilliant Adrian, exactly what I was after, I found myself loosing hours on the internet to find a supplier,
Thank you

Your very welcome Rene! Don't forget the flow bowl end is a 7/16 nut if I recall, so a slightly different ferrule at that end also.

Yes it’s a bugger, two different ferrules, two different nuts, I used to make then in batches but time seems scares at the moment.