I have my kingfisher in pieces due to the Conrod snapping. I have a replacement, and was going to fit new rings whilst it’s apart.
My question is what gap should they have?
The manual for the QB series doesn’t mention gap clearance?
Yet the manual for older models says 0.004 inch (0.1mm)
We did come looking for you down by the river afterwards, The champagne is being held to pass to you at some point, he may have had a trophy aswell? I forget the drink was flowing by then. Let me know when you are likely to be in Lerryn next and I'll get the champagne dropped over to you? Or go and ...
So it made two faultless laps, Capt S even said he eased off at times, well he didn't want to be arrested for exceeding the 6knot limit, yeh right. He cruised in first, but there was no recognition afterwards. At all! Ah well.
Andy, your boat won a bottle of champagne for coming in first! But ...
Ha, I think your right, unless I build my own boat like HA!
Been and bought some SAE 140 today, was just looking for a cheaper alternative as one of my gearboxes must be fairly worn as lets a fair bit of water in!
I know this subject has been addressed a fair bit in the past, but I wanted to run this past you. Now I know Seagull state SAE 140 for the gearbox, but this proves difficult or expensive to find. After a bit of googling, I found a New Zealand website where they state that: The biggest gearbox ...
Hi we have a Clutched Silver Century, and the seal around the propshaft just behind the prop itself is shot. I have checked my normal sources for parts and am struggling to find one? Anyone point me towards a supplier?